“Be sure to bolt your furniture bracing straps to.The patent goes back to the 1930s so there’s nothing new about this particular flavor of wall anchor. A little resistance is good, but if it is too hard to screw in, you may have to take a larger drill bit and widen the hole a tiny bit. Though I haven’t tried this type of wall anchor I’m intrigued with another anchor that Rodriquez mentions, the Molly bolt. Then pull out the drill bit and screw in the screw. The drill will go through the drywall quite easily (proving why you shouldn’t just put your bolt into the drywall) and then will hit the stud and encounter more resistance drill in all the way. WHILE WEARING GLASSES OR GOGGLES, and preferably with work gloves, drill into the wall in front of the stud. Use a drill bit that is just slightly smaller than the solid part of the screw, so that the core of the screw will not need to displace very much wood but the threads will tightly cut spirally into the wood. The threads of a screw may not seem like much, but all those threads carved into the wood and compressing it in the process hold extremely well when pulled upon. These are thick, sharp, and long (like 2 inches) so that they reach through the drywall and into the wooden stud for about an inch. If you know your stud spacing, you can use it as a default, but it’s nice to confirm by actually finding a nail somewhere in the other studs.įor wood studs, a nice long woodscrew or lag bolt of the sort normally supplied with earthquake bracing straps is just fine. The baseboard is a good place to start, but if it is not accessible, then you basically have to keep sliding the stud finder around at different vertical levels until you find a nail, then mark the horizontal location and search for others. This can work well but can also be frustrating, especially in wooden studs, because there are only nails in specific locations up and down the stud, and if you aren’t sliding the stud finder in the correct plane that contains the nails, you’ll sail right by that stud without noticing it. The rod magnet will be flopping around as you slide the stud finder along the wall, but if you slide it past a metal nail in a wooden stud, or past a metal stud, the magnet jumps toward the wall and the other end of the rod sticks straight out as a result, showing you where the nail or metal stud is located. ![]() You can buy these cheaply in hardware stores. A technological step up from this is to use a stud-finder consisting of a swinging rod magnet.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |